Stanton A.2800 User Manual download pdf (Page 6)

PROTECTION

Every model in the A-Series incorporates protection features. The front panel Protection LED indicates the activity of the relay speaker

connection circuitry in each channel. When the protection LED turns on, this circuitry is active, and all connected speakers are muted.

Initial power-up : For approximately five seconds after initial

power-up, the protection circuitry is activated and the speaker

outputs are muted. If everything is operating normally, you will

ear an audible click at the conclusion of this brief period, as the

protection circuitry is deactivated and the unit begins delivering

ignal to the connected speakers. It is normal for the Protection

LED to fade gradually after the amplifier is powered off.

Thermal Protection : Abnormally high heat sink temperatures

will engage the protection circuitry for the overheating channel

only. An output relay disconnects the speakers until normal tem-

perature range is restored. The Protect indicator will light to show

the protection circuit is active. To guard against this problem,

make sure the unit receives adequate ventilation on all sides and

that both the front and rear panels are unobstructed. If the power

transformer gets too hot, its thermal switch will disconnect all of

the secondary power and disconnect both channel outputs.

Short circuit : If output is shorted due to faulty wiring, the ther-

mal circuitry will automatically protect the amplifier. If this occurs,

the load will be disconnected by thermal protection circuitry.

DC Voltage Protection : If an amplifier channel detects DC volt-

age at the speaker output, the output relay will immediately open

to prevent speaker damage.

Subsonic Frequency Protection : The built-in High Pass Filter

provides subsonic frequency protection for each channel.

urrent limiting Protection

At the amplifier’s full power limit, or

clipping point, the limiter circuitry will be activated. This is indicat-

d by illumination of the Clip LED. The channel gain is automati-

cally reduced, protecting the speakers from high power.

ncontrolled feedback, oscillations, or improper equipment gain

setting may activate this circuitry, which is virtually transparent in

operation as full signal bandwidth is maintained.

There is reason to be concerned any time the Protection LED

lights up (except for initial power-up during approximately five

seconds). If this occurs, turn the amplifier off immediately and

check all wiring and external equipment carefully in order to

locate and correct the condition.

Clipping is the result of an amplifier running into power supply lim-

itation. The maximum output voltage that any amplifier can pro-

duce is limited by its power supply. Attempting to output a voltage

(or current) level that exceeds the power supply limit will result in

a flattening effect on the signal. A clipped waveform exhibits

extreme harmonic distortion, making it sound harsh or dissonant.

The clip limiter detects this and reduces the gain to minimize the

amount of overdrive. To preserve as much of the program dynam-

ics as possible, limiting reduces the average program level until

peaks barely clip. Each channel has its own clip limiter, which can

be switched on or off. When driving full-range speakers, clip lim-

iting reduces high frequency distortion caused by bass overload.

It also protects higher frequency drivers from excess overdrive

and harsh clipping harmonics.

Clip limiter

Also known as a low-cut filter, a High Pass Filter rolls off signals

below 40Hz. The reproduction of the signal’s bass portion is thus

optimized, since ultra-low, distracting frequencies are eliminated,

and more power is available for the reproduction of the wanted

segment of the signal.

You should set up the filters so they best suit the frequency

response of your speakers, since some speakers are particularly

sensitive to over-excursion. The 40Hz filter works well with most

compact full-range speakers.

HPF (Hi-Pass Filter)

SETUP

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

Stanton A.2800 User Manual Page 6

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Stanton A.2800